You’re offline. This is a read only version of the page.
Chirping or Other Audio Artfacts Heard From ControlSpace Processor
This article provides information about a known issue and an available workaround
This article contains information about the firmware files that are packaged with each version of ControlSpace Designer software.
This article describes the process of updating the firmware of a Dante expansion card to support 32 channels of input and output.
This article outlines the basic procedure for programming a ControlSpace CC-64 panel with user controls in a ControlSpace program.
Programming Philosophy for Open Architecture Digital Signal Processors - Working from the Outside In
Programming a ControlSpace CC-16 to Control Multiple Gains
Serial Over IP settings for controlling processors, PowerMatch, and PowerShare (Dante model) with a 3rd party controller and Serial Over Ethernet (UDP) settings for controlling endpoints
This article walks through the process of changing the serial port settings of ESP and EX processors
This article explains how to assign volume control to the ControlCenter CC-1 within ControlSpace Designer.
How to configure a ControlCenter CC-2 with an ESP/EX processor
This article explains how to assign volume control to the ControlCenter CC-3 within ControlSpace Designer and how to wire the GPI port.
This article describes one method of creating a system mute state using the GPI terminals on select Bose Professional processors.
This article explains the main differences between using the Scan and Go Online functions
General tips for wiring a CC-16
How to retrieve a ControlSpace Processor's IP Address via RS232
Two methods for using Wireshark to locate Bose hardware are presented.
This article describes the steps to import Bose Dante firmware files into Audinate's Dante Updater for use in firmware updates.
This Article describes how to use the RS232 Port from a ESP/EX in combination with a Terminal Program at your PC
This Article describes how to find out the IP from a ESP-Processor by using the RS232 Port
This Article describes how much Serial over IP Connections ar epossible to a ControlSpace ESP/EX or a network Amp
This Article describes which Dante Update File you have to use for an old ESP-Processor with Dante Card inside